Is It Impossible to Move a Hole in a Piece of Metal? No.... Watch This !!!
Well you know I couldn't just let it go and call it good. This video shows the process I used to move the hole back on location on my pulley arm casting. SHOP GEM INCLUDED !!!! Find it. Link to the original machining of this part: • Machining a Miniature Pulley Arm Casting -... Patreon Support: / joepie Website: https://www.advancedinnovationsllc.com Web Store: https://www.advancedinnovationsllc.co...
▶︎
Saw Cut Garbage. Where Do I Start ?? Don't Miss This One !!
▶︎
The Best Cable - Wire For Audio? Let's Look Closer!
▶︎
A Quick and Simple Method for Making a T Slot Cutter.
▶︎
Casting SALT like Metal - What Happens?
▶︎
I Lifted a 12,000 Pound Machine With One Hand....Part 1
▶︎
Let's Make A Screw Shortener
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎
Magnets Aren't Always Right!
▶︎
350 VORTEC CRACK REPAIR
▶︎
Unusual shop tips Part 2
▶︎
No Way That Was Done With A File ! ..... But, Seeing is Believing :)
▶︎
I made a dead accurate level from scraps (DIY machinist level)
▶︎
How Two Irish Immigrants Built A $75 Machine That Change American Manufacturing Forever
▶︎
RESTORATION of the antique wooden clock "LIGHTHOUSE". Restoration OF THE MANTEL CLOCK.
▶︎
A 3 Pin Fixture That Does All The Work -- You'll Enjoy This One !!
▶︎
How did they make this in the 1800's?!
▶︎
Something is jamming GPS over Europe. Here's what we found
▶︎
The Most Expensive Hinges Ever -- Don't Miss This One !!!
▶︎
Let's Make An Embossing Tool
▶︎