Как изготовить ДЕЛИТЕЛЬНОЕ поворотное УСТРОЙСТВО для фрезерного станка JMD-1

It tells in detail and shows how to make a separating turning device for a milling machine with a lathe chuck with a diameter of 100 millimeters.     On the turning part there are 120 divisions, which allows division into 2, 3,4,5,6, 8, 10,12, 15, 20, 30,40,60,120 parts.    A comparison with another dividing device with a fixed number of divisions is shown - 3, 4, 5, 6 parts. The main disadvantage of it is high height, which limits its use on a small milling machine JMD-1. Especially when drilling with a drill chuck. Not enough vertical feed (stroke) height.     The manufactured dividing device is lower, more rigid and allows division into a larger number of parts.     In the manufacturing process, it turned out that lathe chucks per 100 millimeters of Chinese Soviet production (1976) were completely interchangeable - both in the bore diameter and in the threaded mounting holes.     The separating device consists of two main parts: the base and the turning part, on which the lathe chuck is mounted with a diameter of 100 millimeters. Both parts are turned from sheet steel 12 millimeters thick.     On the turning part there are 120 notes and the figures 30, 60, 90, 120, 150, etc. are engraved. The divisions are applied on a MN-80 lathe (MN-80) using a standard dividing disk and a drill.    The manufacture of mandrels for mounting the drill bit into the tool holder is shown here:    • ОПРАВКИ для КРЕПЛЕНИЯ БОРМАШИНОК на токарн...      In bormashinku installed centering drill. The engraving depth scratches (strokes) 0.2 millimeters, and the length of 1.5 and 3 millimeters.    The figures were engraved on a JMD-1 milling machine with a modified cross table from a tool microscope.    On my channel there are 2 videos showing engraving numbers:    • ФРЕЗЕРОВАНИЕ ЦИФР на фрезерном станке JMD-1   and    • Часовой токарный станок Т-65. Как изготови...     The turning part on the base is fixed with the help of two bars and two M8 bolts.    This dividing device has expanded the capabilities of my milling machine.    The address of this video:    • Как ПРОСТО и БЫСТРО ПОВЕСИТЬ на бетонной с...      I advise you to see the sharpening of the incisors:    • Video      Many tools for the machine can be seen in the playlist: https://www.youtube.com/playlist?list...    I invite to my channel: https://www.youtube.com/my_videos?o=U