ESP32 - How to create your First ESP IDF project (From Scratch)

Learn how to set up your first ESP IDF project using Visual Studio Code, from scratch. We will build a simple example using GPIOs to learn the basics of IDF and how to navigate through the code and documentation. We will also learn how to use the menuconfig, a very helpful tool to configure the main settings for our project. If you like this video, please give it a thumbs up and don't forget to subscribe :) ❗❗❗ IMPORTANT ❗❗❗ ⚠️How to configure your IDF terminal inside Visual Studio code:    • ESP32 - Getting Started with ESP-IDF using...   You will need this for this video. ** Regarding CMAKE ** For a list of reserved words to avoid in your project name, type the following in the IDF terminal: cmake --help-command-list cmake --help-variable-list cmake --help-property-list ▶️ How to Debug your ESP32:    • ESP32 - DEBUGGING your ESP-IDF code using ...   ✅ ESP32 Board Links (Affiliate) ✔ Amazon (Faster shipping) ESP32 Board - https://amzn.to/3weY6SA Debugger ESP-PROG (Recommended): https://amzn.to/3ENsSDy Debugger FT2232H Generic : https://amzn.to/3B1Bxjp Debugger FT2232H Generic Dual Channel: https://amzn.to/3C0NG9G ✔ AliExpress (From China - Cheaper but slower shipping) ESP32 Board - https://s.click.aliexpress.com/e/_AXDp1R Debugger ESP-PROG (Recommended): https://s.click.aliexpress.com/e/_A9n4lJ Debugger FT2232H Generic: https://s.click.aliexpress.com/e/_Ap4yQt Debugger FT2232H Generic Dual Channel: https://s.click.aliexpress.com/e/_9ycDvF ** Timestamps ** 00:00 Introduction 00:40 Why use IDF? 01:17 Setting up the project 02:46 How to use Menuconfig 04:17 Configuring the main settings 06:12 Setting the Firmware version 06:42 Build folder run through 07:25 Coding Example 08:10 GPIO Driver 09:08 GPIO Input Config 10:19 GPIO Pull-up Config 11:06 GPIO Output Config 11:19 GPIO Reading the Input and Activating the Output 12:11 About the vTaskDelay() 12:49 Final Test 12:57 Outro