Canbus SB2240 and SB2209 3D printer Install, Thoughts & Tips from BigTreeTech (BTT)

This video details the install or retrofit of a Voron 2.4 core-xy 3d printer to canbus via the BigTreeTech SB2204 / SB2209 and the BTT U2C Canbus interface ( can bus ) for the Raspberry Pi 4. This shows how to update and configure Klipper onto these cards, mounting, cables, umbilical and reconfiguration of the printer.cfg files. Extra special note: If you are using the SB2240 and you are getting under voltage errors in Klipper, please have a look at this to resolve them: https://github.com/Esoterical/voron_c... Special note: Correction, at about 9:41 in the video I state I'm going to flash the u2c but instead I just flash the SB2240. That's exactly what I did, but my voice over is incorrect. Please ignore what my narration states until I can fix and upload a newer video. A Raspberry PI 4 or CM 4 are highly recommended. People have reported communication issues with the Raspberry PI 3. Devices more powerful than a Raspberry PI 4 are probably fine as well. Resources used (I receive commissions that directly contribute to content creation on this site): The BigTreeTech SB2240 / SB2209 & U2C: https://shareasale.com/r.cfm?b=189092... U2C: https://amzn.to/40K6mG5 SB2240: https://amzn.to/3Nor9Mq SB2209: https://amzn.to/3n6m0y1 The pre-crimped connectors and wires I used: https://amzn.to/3NszA9H The filament: https://amzn.to/3LDNiVG The military green ABS and black ASA filament: https://www.paramount-3d.com/?ref=o45... BigTreeTech github instructions: https://github.com/bigtreetech/EBB/tr... Voron Startup instructions and checks: https://docs.vorondesign.com/build/st... Instagram:   / kapmansbasementworkshop