Cara mengganti potensiometer Multiturn Modul Step UP atau Step Down

@Radal05 How to replace a Multiturn Potentiometer on a Step-Up or Step-Down Module This video explains how to replace the potentiometer on the module. Both potentiometers are 10K ohms. In the example video, a 10K ohm potentiometer is also replaced. A 1K ohm potentiometer is added in series. This series potentiometer makes it easier to adjust the output voltage. Purchase link: Step-Down XL4015 5A CC CV DC Step-Down Battery Charger LED Driver https://tokopedia.link/XAYlgfQSXwb How to replace a Multiturn Potentiometer on a Step-Up or Step-Down Module How to replace a Multiturn Potentiometer on a Step-Up or Step-Down Module This kit is multifunctional as a DC to DC voltage reducer, can also be used as a battery charger, and as an LED light driver. With the voltage and current features, it can be set according to your needs, for example, it can be used as a power supply for all electronic devices with a maximum current of 5A, as an LED light driver, cell phone charger, battery charger because it is equipped with protection to stop the charger when the battery is full. Specifications: Input: DC 5V - 38V Output: DC 1.25V - 35V Current: Maximum 5A (for long-term use and high currents, a heatsink and fan can be added) Efficiency: 92% Working Temperature: -40' - 85'C By purchasing this kit, you understand how to use it. The input must not be reversed between positive (+) and negative (-) as this can damage the kit. To charge 18650 batteries in series, it's best to use a BMS kit and then use this kit. How to replace a multiturn potentiometer on a step-up or step-down module How to replace a multiturn potentiometer on a step-up or step-down module Example of how to charge a battery: Set the voltage and current for the battery type (e.g., a 12V motorcycle battery is usually set at 13.4V - 14V, or a 3S 18650 battery is set at 12.7V). Set Measure the current using an ammeter or multimeter. After all the steps are correct, connect it to the battery to start charging. Example of an LED light driver: Set the voltage and current according to the LED light's specifications. For example, for HPL LED lights, the current should not exceed the LED light's specifications. Set it below the specifications to ensure the LED lasts longer. 00:00 Radal 05 00:13 How to replace a multiturn 00:36 How to remove from a PCB 02:00 XL4015 schematic How to replace a multiturn potentiometer (Step-Up or Step-Down Module)