Zgrzewarka ogniw FNRSI SWM 10

Hello Viewers, Table of Contents 00:00 - Introduction 04:25 - Unboxing 09:35 - Start-up 11:42 - Welding Tests 17:08 - Disabling SHORT-CIRCUIT PROTECTION 26:12 - Successful Welding Today I'd like to show you the FNRSI SWM-10 cell welder, which I purchased to create a pack of LFP 32700 cells, which I obtained from two batteries I showed on my channel a while ago. I bought the welder with my own funds for my own use. In this video, I'd like to show you the unboxing of this device and my first attempts at welding with this welder using an AA battery. The beginnings weren't promising, but later the device showed its true colors, and I must say, it does what it was supposed to do. Although you can't see it in this video, in the next video of my kids' scooter kit, you'll see the welder at work. The device welds strips of sheet metal up to 0.25mm thick. I personally tested 0.15mm and 0.2mm sheet metal, which I had no problems welding. An important setting on the welder to turn off – SHORT-CIRCUIT PROTECTION – should be set to OFF. If you're interested in purchasing this welder, I've included a link below to purchase this device on Allegro, where I bought it. https://allegro.pl/oferta/zgrzewarka-... Thank you for watching the video. I also encourage you to support my channel by: Subscriptions Likes Comments Support button Please also visit my website where you can purchase ESP32 enclosures and other products: https://www.kamtechcnc.pl/obudowy Purchasing our products also means support, which allows us to create more useful content for you. You're cordially invited. Best regards, Kamil & Paulina.