How to Tune The Elegoo Neptune 4 Klipper 3D Printer for Better Print Quality (Step-by-Step Guide)

Here’s how i tuned my Elegoo neptune 4 and 4 pro machines. I hope this helps get you started on your klipper journey, if you have any questions or tips i dont mention here feel free to leave a comment below. Check out todays video sponsor ‪@ElegooOfficial‬ here: https://bit.ly/3oKdmpq (affiliate link) COMMANDS: Run the mesh bed leveling - BED_MESH_CALIBRATE Enable temperature tower - TUNING_TOWER COMMAND='SET_HEATER_TEMPERATURE HEATER=extruder' PARAMETER=TARGET START=200 STEP_DELTA=5 STEP_HEIGHT=5 Run PID tuning Hotend - PID_CALIBRATE HEATER=extruder TARGET=230 Bed - PID_CALIBRATE HEATER=heater_bed TARGET=65 PID value should be formatted this way under the extruder and heater_bed sections: control :pid pid_kp : xx.xx pid_ki : xx.xx pid_kd : xx.xx Pressure advance Run this command first - SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500 Then this command - TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005 Pressure advance model can be found here: https://www.klipper3d.org/Pressure_Ad... #elegoo #neptune4pro #3dprinting