Unboxing, Setup, Test Cuts and First Impressions of the Creality Falcon2 22w Laser Engraver

#Creality #crealityfalcon2 #laser #laserengraver #giveaway #22w Right Folks, very exciting times for the channel as I've finally got my hand on the brand new 22w laser engraver from Creality. As I complete novice in this field I set about unboxing, setting it up with my computer using Lightburn software, run a test cut and a test engraving and offer my initial thoughts on this machine. I made some mistakes along the waym but if you watch this video it will save you the hassle of making the same errors! I will leave links here to the product and their offers, the video from Make With Tech and also my bullet point notes for assembly and setting up. I hope you enjoy the video and let me know what you think in the comments. If you enjoyed the content then please give it a thumbs up and maybe consider subscribing to the channel. If you would like to check out my new website and maybe consider making a purchase or even subscribing to the members only section then please visit: https://www.hand-i-craft.com If you would like to make a one off donation to support the channel then click on the link here: https://www.buymeacoffee.com/handicraft As ever, thank you so much for your continued support in my disability woodworking adventures. Best Wishes, Leo Winstanley All Social Media, Merchandise and Contact Details can be found at: https://linktr.ee/hand_i_craft You can contact us at: [email protected] Make With Tech 1st Look At Creality Falcon 2 Laser Engraver:    • 1st Look the New Creality Falcon 2 Laser E...   Affiliated Link to the Creality Store. If you click on the link below and purchase any Creality product then the channel will earn a small commission: https://shareasale.com/r.cfm?b=201599... “The actual purchased product details are subject to the standard "In the Box" provided on the official website." Code1: Falcon50（£50 Off） My Bullet Point Notes: Unboxing Laser Unpack everything from box Fit foot columns Install laser and use thumb screws to lock it Rubber plug off air hose and attach rubber pipe Plug air pump into side of laser frame Attach silicone hose to laser Put down metal plate and honeycomb Connect power adaptor Installing Laser Install the SD card software onto Mac Click on Devices Import Folder (laser Demo) Creality Falcon 2 SD 4 (software) Lightburn EN Creality Falcon 2.ibdev Click Device Ok Turn on the laser Next to devices. (Cu.BLTH) Click on the port Click Home and print head wobbles Click Lightburn Preferences Select mm/min Edit Device Settings Check ‘Enable Laser Fire button is on’ and ‘Laser on when framing’ is on Turns the laser on low intensity ‘like a soft start on a table saw’ Start from ‘Absolute’ as it allows you to put your material anywhere and then align the laser to match that position Focus the laser Move the laser and use the spacer to adjust the height of the laser unit. The thinner the material being engraved, the bigger the space between the laser and the material Draw a shape Configure the power, the speed and the number of passes required Refer to the configuration chart on the SD card Click on the arrow, select item to be engraved, Input speed on the right side (below white box), then power Home the laser Click ‘Frame’ The laser will then dance around where it intends to cut Before you hit start put your glasses on Then hit START Produces the cut File ‘Import’ Layers of engrave or cut that runs from the top down Can engrave with ‘lines’ or ‘fill’