Gen 1 Raptor to Gen 2 Front Shock Conversion

Check out the trips I do in the truck by subscribing to my other channel!    / @burgers_adventures   In this video I show you how to convert the front shocks on your Gen 1 Raptor to Gen 2 shocks using the Krazy House Customs Off Road and Performance shock mounts! One of the best mods you can do to your truck. It does take some work, but if you know how to wrench, and cut and drill metal, you can do it in your garage just like I did. I'm sorry for the long video but, it's a big job and I wanted to be as detailed as possible. Also, in the video I mention using my stock upper control arm bolts and nuts, if you do this make sure to get new nuts. Honestly, you should just use the hardware KHC sends you! https://khcoap.com/ Tools -Sockets and wrenches (3/4 in, 5/8 in, 30 mm, 21 mm, 15 mm, 13 mm, 10 mm) -Hammer -Pliers -Pry bar -Trim removal tool -Welding blanket -Tape measure (and a marker) -Angle grinder with cut off wheel (or your favorite cutting tool) -Close quarters drill -7/16 in drill bit (I used a 27/64 bit since that's the biggest I could fit in the Harbor Freight close quarter drill) Torque Specs -Upper control arm to frame - 111 lb ft -Upper shock - 30 lb ft -Lower shock - 406 lb ft -Halfshaft nut - 20 lb ft -Tie-rod end nut - 85 lb ft -Upper ball joint nut - 85 lb ft -Brake caliper bracket bolts - 184 lb ft 2010 2011 2012 2013 2014 Ford F150 SVT Raptor Shocks Springs Mounts