Post Oak Shave Horse Build
We found an oak in the dirt and decided to rescue it! This video shows the shave horse as its being built out of white oak. There is no metal or glue used other than some epoxy around the legs to stabilize the wood. We decided to go with a German or Swiss design because my grandfather was German (Seelbach). Our grandson loves to climb around on it and even tried to use it. He demonstrates its use. The Bench log was found here: • Dig Up, Make Buried Post Oak Boards on Cir... The Other Parts were found here: • Removing Stumps & Planting Grass The pin that serves as the pivot is a textile spool rod. Used tractor grapple, chainsaw, Foley Belsaw M-14 circle sawmill. Triple T Ranch & Sawmill on Choctaw Ridge is homesteading with a sawmill & anvil.
Upgraded English Shave horse - Full Build Guide
Build a Shavehorse from Two Boards.
Shaving Horse from 2X4's
Shaving Horse Design - In depth review!
Making a Shave Horse from Start to Finish
Shave Horse Build
A Shave Horse from One Log
RWW 164 Shave Pony
Building A Shaving Horse from log
Building A Bodgers Shavehorse (Complete Tutorial)
Build a Shavehorse from 2x4s.
Manual Foot-Powered Vise? - Build A Shavehorse By Hand
Building a shaving horse from a log with dimensions
Folding Shave Horse - Measured!
An Introduction to Green Woodwork - Part 3: The Shavehorse
Shave Horse - Measurements and Design
Not Your Average Shave Horse: Knock Down Steel and Cedar Workhorse
Shave Horse - My Three Legged Friend
The Roy Underhill - DIY Shaving Horse build.
