Sovol SV03 setup guide (Z-height doesn't work like you expect)

Uncertain about what to buy? Check out THE ULTIMATE FPV SHOPPING LIST: https://www.fpvknowitall.com/ultimate... SUPPORT ME ON PATREON at: http://bit.ly/2Ep5Sia THIS IS MY FULL TIME JOB. Here are other ways that you can support me: https://www.fpvknowitall.com/support-me/ --- In lots of ways, the Sovol SV03 is the same to set up as any other large format 3D printer. But there's at least one quirk that is going to surprise you, and I'll show you how to work around it. What's a Slicer? How I use Cura to slice files in preparation for printing.    • 3D Printing | What's a slicer? My Cura wor...   -- PRODUCT LINKS -- I receive a commission (at no extra cost to you) if you make a purchase after clicking one of the affiliate links below. Buy the Sovol SV03 at: Sovol - https://bit.ly/38X7xdA Amazon - https://amzn.to/2XYKqct Buy the Sovol SV01 at: Amazon - https://amzn.to/33Q2O7F Sovol - http://bit.ly/2DRp6eY MANDATORY DISCLAIMER: I am a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for me to earn fees by linking to Amazon.com and affiliated sites. Most or all links above are affiliate links, and I will receive compensation if you use them.