I make a Twisted Steel Rebar Industrial Style Handle - MIG Welding Project.

I make a Twisted Steel Rebar Industrial Style Handle. I love the look of industrial furniture and all the decor that comes with it, and this handle has the look I like. I hope you enjoy my video of the metal twist handle, it was a lot of fun to make a nice MIG welding project. The wide flat bar is 6mm thick, 50mm wide, and 225 mm long. The small flat bar is 6mm thick, 32mm wide, and 57mm long. The rebar is 7mm. The distance between the two uprights is 145mm. The main tools used are a MIG welder, angle grinder, drill, and bench vise. The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au ►►Subscribe to our Channel for more videos ►► http://bit.ly/2ULxLJogavinclark Always use all the correct safety gear, and use your tools safely. I am not a good role model for this. Hope you found something of use in my video or at least found it entertaining. Gavin Clark DIY Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar