G&E Shaper Oil Sump Cleanout
The oiling system on this G&E shaper has been long neglected. It's time for a full clean out of the oil and the sump. I happened upon a freebie piston pump that I used to remove the old from the shaper. No secrets, just nasty hands on work to get the oil out and get the sump cleaned from all of the sludge!
▶︎
G&E Shaper New Oil and Run In
▶︎
G&E Shaper First Time Start Up & Run
▶︎
The Strangest American Engine Ever
▶︎
G&E Shaper Tool Head Tear Down
▶︎
This Engine Breaks ALL the Rules
▶︎
IDIOTS AT WORK Mechanic Edition | Part 2
▶︎
G&E Shaper Ram Way Sight Oilers, New Felt & Oil Sight
▶︎
America Had No Radio Crystals in 1941 — So Engineers Cut 30 Million From Brazilian Quartz
▶︎
The 90-Degree Torque Problem
▶︎
I restored a milling machine for my birthday. It went well, mostly.
▶︎
Bronze Thrust Bearings for Shaper Tool Slide
▶︎
Shaper Slotting
▶︎
The Spinning Giants: Flywheels That Stored Dangerous Power
▶︎
Morey Vertical Shaper Feed Box Oil Pump Repair - Manual Machine Shop
▶︎
Shaper Machine - Involute Gear Cutting
▶︎
SNS 209: Measuring Lead Screw Backlash, Chasing Acme Threads
▶︎
The Ten-Engine Titan: Inside the B-36 Peacemaker, The Cold War’s Largest Bomber
▶︎
Why the Mack Maxitorque is Bulletproof
▶︎
What Happened to the Cox .049? | The Engine That Couldn’t Survive Modern Childhood
▶︎