Como sacar el aire del radiador y del sistema de enfriamiento del motor ( purgar anticongelante )

Tutorial: How to bleed air from any car's radiator and the entire engine cooling system. This involves bleeding the antifreeze, also known as coolant, to prevent the car's engine from overheating. It is mandatory to bleed air from your vehicle's radiator and the entire engine cooling system when changing the antifreeze, the water pump, the thermostat, and any hoses that carry the antifreeze, also known as engine coolant. In this case, I'm going to fill the radiator of a Nissan Tiida with antifreeze and the engine cooling system to eliminate all the air, because it causes the following problems: loss of engine power, excessive fuel consumption, engine overheating, the radiator fan motor takes a long time to turn on, and when it does, the fan motor shuts off very quickly, noises or bubbling are heard in the radiator and engine, and when I turn on the heater, the engine temperature gauge or needle suddenly rises and falls, no hot air comes out when I activate the heater in hot air output mode, and the red temperature light on the instrument panel comes on. Funnel Purchase Link: https://s.click.aliexpress.com/e/_mry... 3/4 Masking Tape Purchase Link: https://s.click.aliexpress.com/e/_mrU... Nissan Blue Antifreeze Purchase Link: https://www.mercadolibre.com.mx/p/MLM... Chapters: 00:00 Context 00:14 When to bleed air from the engine cooling system (bleed antifreeze) 00:39 Engine failures when there is air in the radiator and the car's cooling system 01:32 Explanation of bleeding the radiator and the Nissan Tiida's cooling system. 01:52 Materials to be used to bleed air from the radiator and engine cooling system (bleed antifreeze and coolant) 02:03 Step one: Remove the radiator cap, check the coolant level in the reservoir, and insert a funnel. 04:31 Step two: Start the engine and squeeze the radiator hose to release any air bubbles. 07:24 Step three: Let the engine warm up to a temperature between 82°C and 90°C and open the thermostat. 08:14 Step four: Turn on the car heater in hot air exhaust mode. 09:15 Step five: Turn off the car heater. 09:57 Step six: Let the engine warm up to a temperature of 90 degrees Celsius (°C). 10:26 Step seven: Turn off the vehicle's engine. 10:51 Step eight: Let the engine cool down. 11:00 Step nine: Fill the radiator with antifreeze (refill with fresh coolant). ) 12:03 Step Ten: Replace the radiator cap 12:26 Step Eleven: Start the car engine and let it warm up to a temperature between 95°C and 98°C 13:15 Step Twelve: The engine is now warm, at a temperature between 95 and 98 degrees Celsius 13:48 Step Thirteen: Let the car engine cool down 13:55 Step Fourteen: Check the coolant level in the tank 14:38 Recommendation if the radiator and engine cooling system are improperly bled 14:54 Other solutions when the engine overheats and bleeding the air from the radiator and engine cooling system (bleeding the coolant) doesn't work 15:38 Conclusion: Important videos that may interest you 16:11 Farewell