How To Use a Process Meter - (5 Step Guide to Source / Simulate 4-20mA)

In this video I show you how to use a process meter to source or simulate 4- 20 mA using a fluke 789 process meter on Instrumentation loops. I also talk about the different modes and how to determine the setup of aa current loop. In this video, I’m going to show you an easy to follow 5 step guide to using a fluke 789 process meter - for sourcing or simulating 4-20mA loops, perfect for a whole host of instrumentation calibration and fault finding needs. Quickly, before we move onto to the steps on how to use the fluke 789. we should discuss the difference between sourcing and simulate modes. Transmitters and other sensors that give 4-20mA signals are connected to a plc or other input device that reads the current within the loop. These current loops are usually 24v DC powered. These Instrumentation loops can be either have the 24Vs powered from the input card or the transmitter is externally powered and it provides the 24Vs for the loop power. When using a process meter in place of transmitter to test a loop you will need to use it in a different mode depending on what is powering the loop. If the transmitter was supplying the loop power, you’ll need to source the loop. If the input card or isolator is powering the loop, you’ll need to simulate the loop. Lets now lets look at the steps you’ll need to source or simulate, afterwards I’ll go through a few tips how to identify how a 4-20mA loop is setup so you will know what mode to use. Remember electricity is dangerous, so only work on equipment you are competent to do so! And always check the voltages you are working with. ▶▶Check out brilliant T-shirts / Merch at my store: https://www.redbubble.com/people/rudd... ▶▶Check out my website for more articles on Instrumentation: https://www.instrumentationcontrol.in... ▶▶ Amazon Affiliate link to Fluke 789 - https://amzn.to/3fhDQWj ▶▶ Fluke 117 guide for voltage and resistance operation modes -    • How to Use a Fluke Multimeter [ Fluke 117 ...