Suzuki DF140 Tilt/Trim Limit sensor replacement and reprogramming

This outboard was having some weird quirks with the tilt and trim, The trim sensor was sending erratic readings to the ECU which was causing it to stop moving randomly. A replacement sensor is not hard to install, but does require a lot of cowling to come off in order to route the wires. After the sensor is installed, the trim limits will need to be reset. 0:00 Explanation of problem 1:36 Location of sensor 2:18 Electrical Connector location 3:28 Installing the new sensor 4:28 Removing upper trim limit 5:16 Setting Trim up limit 5:55 Testing Up limit 6:52 Down limit 34840-98J03 Trim sensor: https://ebay.us/pBRGbg While you're perusing youtube, check out some of our friends channels: Dirt road recovery:    / @dirtroadrecovery   (Off road recovery, Fabrication, SXS) Laplanet:    / @laplanetarts   (Tech, Creative, Art) Become a channel member to get early access to videos and help support what I do:    / @trythistv   Links here are most likely affiliate links, should you choose to purchase from one of them, I may earn a small commission for referring you to the seller. And, this is done at no extra cost to you!