Аксессуары для тюнинга рыболовного каяка с педальным приводом Kingfisher point 65.

This video is for the experienced. Somehow in the comments I often came across recommendations for modifying my kayak with customized parts and assemblies made on a 3D printer from a glorious master from St. Petersburg. I studied the assortment for a long time, I even had to register again in VK, where I had not been for 12 years, just so that I could conduct a dialogue and place an order from this experienced person. In general, everything was so well thought out and thought out, for such little money that my brother was simply shocked. He said such an idea and development should cost many times more. So on the list 1. Trays on board for bait - 2 pcs. They are installed between the side and the railing and can move. Two versions - with with or without a partition. Water drainage is provided. Install the trays with their bulges facing the pipe. 2. Footrests - 1 set (2 pcs). Used when rowing if the chair is set to the far position. Attached to the rails with T-bolts. The most convenient position is at the end of the rail. The stops do not interfere with the use of the pedal drive. 3. Steering wheel lockers 1 set (2 pcs). To protect the standard mount from impact and abrasion. The heels are pressed with standard screws. 4. Mounting the Impulse Drive pedal drive. With these fasteners, the drives sit more securely and do not wobble or pull out the cage nuts under excessive load. 5. Pedal drive stop. Used to reduce the load on cage nuts. Consists of a removable part, a lock and a locking knob. 6. Universal holder with elastic band Mounts horizontally, vertically, in any direction. For example, you can attach a side-mounted echo sounder sensor to it. 7. Flexible mount for camera and phone - Flexible rod NMBG-48M 8. Telescopic monopod for a 3 m camera. Video content 00:04 - briefly what the video is about, what’s in the package 00:19- Trays on board for bait, installed on kayak rails 00:57- Foot rests for long paddle trips 01:56- Steering wheel stoppers during a long passage on an oar (rudder locks) 02:33 - Protective heels for handlebars 02:53 -Impulse Drive improved pedal mount 03:40 - Impulse Drive pedal support to reduce the load on the embeds 05:19 - Universal holder with elastic band 05:39 -Flexible mount for camera and phone (withstands 700 grams) 06:00 - Telescopic monopod for a 3 m camera. 06:42 -After several days of rafting, I show all the kayak tuning accessories and give my intermediate assessment to each of them.