(OLD VERSION) Installing a Red Dot in the Omtech Polar Laser Cutter

Check out the newer and shorter version of the video here:    • Add a Red Dot to your Omtech Polar Laser C...   Easily add a red dot site to your Omtech Polar laser cutter with this drop in kit. Available at https://mas-effects.com/omtech-polar-... UPDATES: 1. I forgot to mention, you can twist the tip of the red dot laser to adjust the beam brightness and focus. 2. Newer units ship with bigger drag chains, so instead of using a zip tie you you can secure it with the screw you removed 3. No need to unscrew the controller and lift it up. Just pull the connectors straight up and they will unplug. Screw in the wires, then plug it back in. 4. Instead of fine-tuning the alignment, you can use the "Laser Offset" setting in Lightburn to compensate 00:00 Introduction 01:54 Remove left panel 03:18 (optional - FYI) If you're adding a Ruida panel, do it now. More info here:    • Huge Upgrade on the OMTech Polar   04:00 Plug red laser into controller 07:55 Secure the cable 09:33 Attach the red dot assembly 11:40 Rough beam alignment 13:30 Fine beam alignment 16:55 Check cables 18:10 Reinstall left panel 20:12 (optional) Re-enable "door open protect" 20:45 Head cover and cleaning