✅Как почистить аварийный слив (ФИЛЬТР, МАНЖЕТ) LG —пошагово cleaning drains (FILTER,CUFF) #dmitryS_M

✅ 1. Unplug the machine Safety first. Switch off the machine and unplug it. 2. Open the lower service cover Located at the bottom in front, usually on the left. Open with your hand or a flat screwdriver. 3. Place a basin under the emergency drain Inside you will see: Drain filter cover (with thread) A rubber tube with a plug - this is the emergency drain 4. Carefully remove the plug from the tube Slowly and carefully, because water will start to flow. Drain all the water into the prepared container. ❗ If the water flows very slowly, the tube may be clogged. 5. Rinse the tube You can carefully blow through it (or pull it through with a flexible wire). Rinse the outside and inside with a stream of water (if you can reach it). If it is very dirty, pull the tube out of its seat (if the model allows it) and rinse it under the tap. 6. Clean the pump filter While you are there, unscrew and clean the pump filter (near the tube). Debris, coins, and hair often accumulate there. 7. Put everything back in place Close the tube with a plug. Insert the filter back. Close the lid. 8. Check the operation Turn on the machine and run a short program (e.g. spin or drain) to make sure everything works without leaks. 🔁 How often should I clean? Every 2–3 months — for prevention. After drain errors (OE / E1 / FE, etc.) If you smell or the water is standing after the cycle #washingmachine #washingmachinerepair #master_DI home #DmitryS_M #washingmachine #pumpreplacement #doityourself #washingmachine #ukraine #dmitryS_M