VL pedal adaptor redux - RAW MACHINING!

Stocks were getting low, so it was time to machine a new batch of my VL throttle pedal adaptors. Since the first video i did of these, i've since sold the machine that i did most of the work on, so I've reprogrammed it to be all run on the MV1400 in a kind of 1 and done fashion. (one piece of raw stock goes in, one finished part comes out after going through 3 stations) Due to the MV1400 being a much faster machine, that can read code a lot faster i was able to make a few changes to speed the process up, and use better tooling (mainly better as far as chip control is concerned.) This whole video is in realtime.