Pixhawk Unboxing and Installation in QAV500
Thanks to GetFPV for sponsoring this video: http://bit.ly/10My7Av This is the 1st video in a series that will show everything from installing Pixhawk to mission planning with DroidPlanner in a QAV500. The next video will show firmware loading and configuration of APM:Copter firmware. If you have any questions or comments please post them below and thanks for watching.
▶︎
QAV500 & Pixhawk Firmware Load, Calibration & Stabilize Garage Hover
▶︎
3DR Pixhawk Installation Part 1 - Physical Connectons
▶︎
QAV500 & Taranis X8R SBUS with NAZA Flight Modes, IOC, and Failsafe
▶︎
Pixhawk 6S Lipo Heads Up
▶︎
Unbelievable Workers | Working with Talented Engineers #46 #fail #adamrose #smartworkers
▶︎
Building the Smallest Possible Long Range FPV Drone
▶︎
Qgroundcontrol основные настройки Pixhawk. Это просто!
▶︎
The Surprising Flaws in 18650 Lithium-Ion Batteries
▶︎
Pixhawk Locks Up with Retracts - Always Use BEC to Power Servos
▶︎
3D printed mini speed drone
▶︎
QAV500 17 Minute Flight Time with 6200mAh Tattu Battery and Pixhawk
▶︎
The Deadliest Weapon of the Ancient World
▶︎
I Modified My Bicycle To Run Lightning Fast. Everyone Was Amazed!
▶︎
How To Connect & Config 3DR V1 915MHz Telemetry Radio for Pixhawk APM
▶︎
4G (LTE) Telemetry and Control of Pixhawk using Pi3
▶︎
Pixhawk AutoTune How To
▶︎
APM/Pixhawk Tips for Good Loitering
▶︎
Creating the World's Most Efficient Drone
▶︎
PixHawk Quad Build - Setup 6 Flight Modes on FrSky Taranis for APM or Pixhawk Flight controllers
▶︎