generator fix

In this video I show how we did the troubleshooting and repair of the Onan Emerald Generator from my 2000 Workhorse based motorhome. An overview of the renovation of my Georgie Boy Pursuit Motorhome on a Workhorse P32 Workhorse chassis can be found at:    • Intro to 2000 Workhorse motorhome renovation  &t=0 Generator Issues Generator fix:    • generator fix   Getting Workhorse ready to put back on the road A few parts and tools for the new engine:    • A few parts and tools for the new Vortec e...   Old motor stripped – cause of failure determined:    • The reason my Workhorse motorhome vortec e...   Motor moved to shop:    • Motor to shop   Motor is out:    • Motor out!   Part 6 of engine removal:    • Engine Removal part 6   Part 5 of engine removal:    • Engine removal part 5   Part 4 of engine removal:    • Engine removal part 4   Part 3 of engine removal:    • Engine removal part 3   Part 2 of engine removal:    • Engine removal part 2   Part 1 of engine removal:    • engine removal part 1   Plan and tools for engine swap:    • Plan and tools to swap engine: a tale of t...   New motor arrived:    • New motor arrival   Disaster struck just before test drive:    • getting ready to go! Then Disaster!   Front wheels back on:    • Front wheels on the Motorhome!   Reinstallation of the left front brake shield/panel:    • Front brake shield reinstall   Rear end back on the ground:    • Rear end of my 26 year old Workhorse motor...   Differential Oil Change:    • Changing differential oil on Workhorse   Putting the rear wheels back on:    • rear wheels back on Workhorse motorhome   Inspecting and lubing the driveshaft:    • driveshaft and differential lube   Chapters: 00:00 Intro 02:03 Cleaning the carburetor 03:30 Removing the generator 04:33 Brushes and slip rings 05:10 Cleaning the slip rings 06:40 Checking power output 06:57 New oil pressure sensor 08:18 Testing the oil pressure sensor 09:01 New Control board 10:51 New Voltage Regulator board 11:51 Electrical Tests guide 12:07 Measuring resistance between pins 9&10 12:58 New Brush Block, brushes and springs 14:24 Install and test new voltage regulator board 15:18 Faulty oil pressure sensor 15:32 Generator works! 17:55 Wrap-up