I 3D Printed Rear Diff Bushes For My TVR — Round 2 Fitted

#3DPrinting #CarRestoration #TVR 0:00 Haircut update + what we're doing today 0:20 The 3D printed bushes (and the cone) 1:55 First bush — squeeze it in 6:30 Second one in, the struggle bus 9:52 The rear top-hat bush 10:23 Wrestling the diff back into the car 13:10 Round 2 — finishing it off 15:43 Bonus: fuel and brake lines 20:11 Wrap up — place your bets on the bushes Round 2 on making polyurethane suspension bushes from 3D printed moulds — and this time they're getting fitted to the car. Three rear diff mount bushes for the Cerbera, made from PLA moulds and poured polyurethane, then installed on Saturday. After the first attempt last month was a bit rough, I redesigned the moulds, mixed a fresh batch, and gave the cure time longer. Three usable bushes this time — and the install was, well, eventful. If you want to see how the first attempt looked:    • Custom 3d printed poly bushes. PVA moulds !!!   Full write-up on the wiki: https://tvr-wiki.co.uk/mods/3d-printe... Dinner was hot dogs — what did you have? Let me know in the comments. Only time will tell how well this all lasts , but its mine    / @mattgreenworks     / mattgreen16v   https://www.amazon.co.uk/hz/wishlist/... [email protected] ( use paypal ) website : https://16vmini.co.uk Facebook :   / mattgreenworks   twitter :   / 16vmini   Instagram : instagram.com/16vmini email : [email protected] --------------------------------------------------- Close Suppliers of Mine ,would recommend them , please pass on my name if you order anything : https://www.vintagetyres.com//?ref=ma... https://absmotorsport.co.uk?ref=mattg... https://silentcoat.co.uk?ref=mattgree... (order from www.deadening.co.uk , use code "mattgreen10" for 10% off silentcoat) https://www.frost.co.uk?ref=mattgreen16v https://playmini.co.uk/?ref=mattgreen16v https://northstarwrap.com/ https://www.waveshare.com/ https://www.elecrow.com/