Isuzu Upper & Lower Ball Joint Replacement - Rodeo/Trooper/VehiCross/D-Max/Bighorn

Isuzu Upper & Lower Ball Joint Replacement - Rodeo/Trooper/VehiCross/D-Max/Bighorn Replacing the upper and lower ball joints on an Isuzu. The repair will be much easier on a 2wd Isuzu since the front axle will not be in the way. The vehicle in the video is a 1999 Isuzu VehiCross, but the procedure will be almost identical on the other models listed in the title. I recommend spraying down the ball joints, tie rod, and all bolts with a liquid wrench (rust dissolver) spray a day before doing this job. Tools I used: 10mm socket 14mm socket 16mm socket (new ball joint bolts) - may not be necessary 17mm socket 17mm deep socket 19mm socket (lug nuts) 22mm socket 23mm socket Hex 5 socket Hex 8 socket 14mm wrench 16mm wrench (new ball joint bolts) - may not be necessary 17mm wrench Breaker bar Ball joint separator Needle nose pliers Crescent wrench Vice grips Mallet/Hammer Secondary Jack to hold up control arm Tools I would heavily recommend: Liquid wrench spray Impact wrench Wire brush Snap ring pliers Isuzu VehiCross Isuzu Trooper Isuzu Rodeo Isuzu D-Max Isuzu Bighorn Ball joint replacement