Dynaco ST-35 Clone (using ST35 circuit) another EL84 Stereo Tube Amplifier
A similar clone of a Dynaco ST-35 EL84 stereo tube amplifier. Here I used the ST-35 driver circuit but instead of an ultralinear hookup I used Heyboer HTS-10645 output transformers connected in pentode mode for a great sounding amplifier! Schematic Here - https://www.dropbox.com/s/u6iweef5sec... Wiring - https://www.dropbox.com/s/051unqeoech...
▶︎
Dynaco ST-70 Original vs. VTA Bench & Listening Test Comparisons - Stereo 70 Tube Amp
▶︎
DIY Classic Tube Amplifier – Dynaco / VTA ST-120 Review
▶︎
Look Inside This Tube Amplifier!
▶︎
What does the Choke in a Tube Power Supply do?
▶︎
Stanford Research Systems SR510 Lock-in Amplifier
▶︎
TTT082 Tube Circuits
▶︎
Tube Audio Amplifier Troubleshoot Repair and Modification
▶︎
How to Wire Tube Amp Filaments the Correct Way - W.I.S.C - GT5 'Halcyon' Build 1
▶︎
Dynaco ST70 vs ST35 with sound demo
▶︎
Dynaco MKIII Full Rebuild + VTA 6SN7 Driver Board Upgrade & Testing
▶︎
How Tube Amplifiers Work, Part 2: The Pre-Amp and Power Amp
▶︎
Tube Amplifier Repair, and what to look for.
▶︎
DIY 6L6 SE Stereo Amplifier using PSVane Horizon Tubes
▶︎
The Obsessive Engineering of Precision Linear Motion
▶︎
Galion TS120 Review and experience
▶︎
Tube Amp Power Supply Design
▶︎
HighEnders hate me for this!?! | #CABLESOUND viewed objectively
▶︎
Tube Amp Design: Driver Tube Selection and Load Lines.
▶︎
Can I Build It In 10 Minutes? The Dynaco VTA ST-70 Amp Kit
▶︎