How to install a tap on a water tank, barrel/ faucet connecting, Bulkhead tap fitting

In this video I'm going to show you how to install a tap on a water tank, plastic bucket or plastic barrel keep in mind that the main components needed to install a tap on a plastic bucket, water tank or a barrel are the same So you are going to need the following materials 1. Bulkhead connector 2. A tap 3. thread seal tape 4. Drilling equipment in this case I used three quarters four Inches piece of iron pipe and pliers to drill the hole so if you don't have a drill it's fine So heat up your metal to get enough temperature to drill a hole Make sure that you don't drill a very wide hole as this will bring difficulties in sealing of water, just drill a simple hole that your bulkhead can fit Then put your bulkhead In a correct manner as I did Wrap a thread seal tape around your tap thread to ensure that there will be no leakage of water Then connect your tap to a bulkhead Add water to your tank to check if there is no leakage on the tap Thank you so much for watching please don't forget to SUBSCRIBE and leave a comment if you have any question or opinion