Suzuki RM 250 C2 Assembly, Throttle cable Fab
In this video I assemble more of the 78 1/2 Suzuki RM 250, I also have to make a new throttle cable. I ran into a lot of issues on this bike, the throttle cable was too short, the front brake cable was too short, the clutch cable was too long, the expansion chamber would not fit, turns out it's for an earlier RM 250 probably a RM 250A or a RM 250 B model. Other than those problems the assembly went pretty good.
▶︎
Suzuki RM 250 C2 chain tensioner fabrication
▶︎
Suzuki RM250 C2 In the box project, will it run
▶︎
Suzuki RM 85 engine assembly
▶︎
Fixing A Dirt Bike Carburetor That Leaks Gas Out The Bottom
▶︎
Lets get my Suzuki GT185 back up and running after sitting for 10yrs
▶︎
Suzuki RM250 C2 repairs
▶︎
He Was In The Hospital when We Showed Up And Surprised Him With Over $100,000!! Hand Delivered!
▶︎
Yamaha YL1 seized engine teardown
▶︎
Why Are Japanese Motorcycles So Hard to Beat?
▶︎
I Built a 3 Cylinder TWO STROKE Bicycle (From Scratch)
▶︎
Seller Lied About This Rare 2-Stroke Dirt Bike
▶︎
IS THIS 1969 Suzuki TS250 Savage THE NICEST ONE LEFT?
▶︎
79 Suzuki DS80 engine build part 1 and Lexivon torch review
▶︎
Suzuki DS80 disassembly, Lexivon torque wrench review
▶︎
27 year old DIRT BIKE Gets New Life (RM 250 2 stroke)
▶︎
79 Suzuki DS80 lower end teardown
▶︎
1978.5 Suzuki RM250
▶︎
Honda XL75 to XR75 exhaust, stator, set points, timing, cables
▶︎
I BOUGHT A NON RUNNING DUCATI 996...WILL IT START?
▶︎