How to install the Sprite's front springs with the suspension in place. Bugeye Build Episode 74

The Frogeye's front springs are installed after putting in the new bump stops. I replace the clutch fork bushing and get the gearbox ready to be united with the new engine. Just a quick disclaimer... this may not be the "correct" way to do this job but it's how I did it with what resources I have on hand. We would love to hear from you! If you have a questions or suggestions please leave them in the comments section or send me an e-mail at the address below. Follow our adventure with what I hope to be fairly regular updates. Leave any questions in the comments section below. Please like, comment and subscribe... oh, and hit that little bell icon so that you'll be notified when the next video is available. Once you've done that check out our social media links! E-mail: [email protected] Instagram: www.instagram.com/i_c_cars/ Blogger: www.econoboxcafe.com Artwork for profile picture, start and end screen used by permission: https://bit.ly/3sSLcrC If you’d like to support Econobox Garage you can do so while shopping on Amazon by clicking on our Affiliate link first. It doesn't cost you anything extra and we make a small commission from qualifying orders. Amazon Canada: https://amzn.to/3BgXpZV​ Amazon USA: https://amzn.to/3DaanIv​ Equipment used to produce this video: Canon PowerShot ELPH 180 Amazon Canada: https://amzn.to/3mK06Oh Amazon USA: https://amzn.to/3zvxlZi Motorola Moto g7 play Amazon Canada: https://amzn.to/38oZBRh Amazon USA: https://amzn.to/3DusPN1 Thanks for joining me in the garage! #bugeyesprite #frogeyesprite #austinhealeysprite #mk1sprite