Замена Прокладки Головки Блока Цилиндров М111 - Установка Метки Зажигание

Friends, to replace the gasket, first you need to check the cylinder head for warpage and grind it on a lathe. Next, to secure the bolts, you need to completely dry the bolt seats. Now we install the camshafts, and each fastener goes back in its original place. Friends, to reassemble the engine ignition, once everything is ready, you need to set the crankshaft to 21 degrees. This is when the chain is new. Now we align the camshafts so that the holes align. We check with slightly smaller bolts to ensure they don't wobble. We place the chain on the camshaft and tighten it completely, checking that the chain isn't sagging. Now we install the second camshaft in the same way as the first. We check with a bolt to ensure the holes align. Next, we reinstall the sprocket, tensioner, and chain guide. We completely disassemble the tensioner, install the pin into the tensioner housing, screw the tensioner housing in, tighten it, and then assemble the spring and nut into the tensioner housing. This means we're resetting the tensioner; otherwise, the chain could break. Now that everything is ready and all the marks are aligned, rotate the crankshaft twice, and check the marks on the camshafts again. If they match, everything is fine. Support the channel: 6768 6771 7988 5664 (ferecov samir)