Active Target Yellow Wire Fix Update Installation
Marc Marcantonio shows you how to install the Lowrance Active Target update that allows the use of the yellow wire to both wake-up and turn-off the Active Target module and transducer. Having the independent ability to turn off the AT system will save power, and protect the Active Target transducer from damage and wear. Marc shows you how this works on his bass boat, and how his is wired for maximum flexibility and power conservation.
▶︎
Lowrance LIVE | Active Target Installation
▶︎
Control Your Active Target Module with a Switch (Way #3)
▶︎
Active Target Transducer Problems & How to Fix it!
▶︎
5 Ways to Control Your Active Target Module
▶︎
Active Target Setup Steps
▶︎
Dual Active Target 2 Installation, Part 2. Installing dual units and leveling transducers.
▶︎
10 ILLEGAL Tricks That Make Your Outboard Engine Run BETTER!
▶︎
Installing Marine Electronics | The Ultimate Guide Series
▶︎
How to install Lowrance Active Target Sonar
▶︎
Active Target 2 Power Cable with the Sync Wire
▶︎
Lowrance Active Target Install (Full Instructional Video On 16" HDS Live/Ghost)
▶︎
Dual Active Target 2, Part 1, Unbox and Install Wiring
▶︎
How To Update Lowrance Active Target Transducer
▶︎
How I make connections for power cords when I install fishfinders.
▶︎
Fitting Your Transducer to Read at Speed
▶︎
Active Target Power Wiring
▶︎
SNIPING Brush Piles with Lowrance ACTIVE TARGET
▶︎
The Best Live Sonar Transducer Mount
▶︎
Lowrance ActiveTarget wiring tutorial (ice fishing)
▶︎