CB350 Clutch Adjustment Procedure

Follow me on instagram, @njdnjdnjd This a video walk through of a Clutch setting procedure that might just solve your shifting problems. I got it off Hondatwins, a guy named Steve posted this http://www.hondatwins.net/forums/48-e... Make sure to print it out, and check off each step. cb350/360 clutch adjustment procedure Put slack in the cable.... I recommend you "set" the threaded adjuster at the handlebar perch at about 1/2 way in....That way you have some adjustment left in either direction. Cable bottom adjuster (at case cover): thread it ALL the way in so you have maximum slack inside...... With case cover off engine, VERIFY the #10 ball bearing is in place (grease it in).... Loosen adjuster locknut on case and screw the slotted bolt FULLY CLOCKWISE until it stops (This is the maximum clearance point, "Arm" should be fully " down" as pulled by the spring)..... Replace cover and snug the Phillips head screws...... Tighten the slotted adjuster COUNTERCLOCKWISE (anti-clockwise) until you feel it start to apply pressure to the clutch (you actually feel the springs push back)... Turn it CLOCKWISE until the pressure JUST releases, Then 1/8 turn CCW, and snug the locknut...... Pull the clutch lever against the grip..... Tighten BOTTOM cable adjuster (out) until the lever JUST touches/closes at the perch.....Lock it in place...... Minor adjustments for desired lever "reach" and release points can now be done at the UPPER (perch) adjuster........ It took me longer to type this than it should take to adjust the clutch......... Steve