Balancing a 4-Jaw, D1-4 Camlock chuck. Guess how many grams it was off! WOW!
My independent 4-jaw chuck for my Grizzly lathe was WAY out of balance since day-1. So I figured I'd balance it, but I had to work through the dumb ways before figuring out the SMART way! The chuck was so far off balance, you won't believe the amount in grams it was off! Watch and find out! Videos/Channels mentioned in this video: Rotary SMP: / @rotarysmp Haxby Shed: / @haxbyshed
▶︎
Grizzly G4003 lathe, loud BANG noise FIXED! The problem WASN'T the Bearings or gears!
▶︎
Trump Gets Booed & Falls Asleep During NBA Finals, Claims War is Almost Over & Goodbye Spencer Pratt
▶︎
HOW TO MAKE A REAMER FROM SCRATCH
▶︎
The Professor Who Taught People How To Think (1962)
▶︎
How a Failed Hedge Trimmer Company Built American Manufacturing
▶︎
Grizzly G4003 lathe, loud BANG! from the gearbox. Let's dig into it! Video #1
▶︎
Was I Wrong about the Drill Doctor?
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎
The 90-Degree Torque Problem
▶︎
100% machining solution / Kobalt 3332643 air comp. regulator. It works PERFECTLY!
▶︎
TOTAL IDIOTS AT WORK #150 | Instant Regret Fails Compilation 2026 | Best of the Week
▶︎
Unbelievable Smart Workers | Genius Construction Skills, Crazy Fails | Part 114 #construction #smart
▶︎
THE MILL IS SCREWED
▶︎
Making A Lathe Chuck Back Plate
▶︎
Single Point Threading a 2-7/16" Pump Shaft
▶︎
Unusual Shop Tips
▶︎
The Pressure was On for this Urgent CAT 637 Cylinder Rebuild
▶︎
Once You Understand it, You Will Think Everything Else is Silly - Toyota E-CVT
▶︎
Magnets Aren't Always Right!
▶︎