How to Install the firmware of crossflight?

The parameters of crossflight can be set in RadioLink Mission Planner, ArduPilot Mission Planner, and QGC, but crossflight can only install the firmware by RadioLink Mission Planner and only supports RadioLink firmware.  The Mission Planner can be downloaded from RadioLink official website (附crossflighthttps://www.radiolink.com/crossflight.... Here is RadioLink Mission Planner for crossflight. It has already been downloaded on the computer. The default firmware of crossflight is for Multicopter. You can install other firmware you want. Connect crossflight to the computer via the USB cable, which comes with crossflight. (Do not install new firmware by wireless data transmission) After connecting it, click SETUP--Install firmware. Before installing firmware, we must check if crossflight is recognized. It can be seen in the status here. If it is not recognized, unplug the cable and plug it again. (Do not click CONNECT when installing the firmware) It pops out found board here, which means crossflight is recognized now. There are two ways for you to select the firmware and install it. You can either click the icon directly to install the firmware or click Load custom firmware to install the firmware you downloaded from RadioLink website. Are you sure you want to upload ~~~？ YES. Platform- select crossflight--Upload Firmware. The green bar is moving. The blue LED is also flashing when installing the firmware. Now firmware is installed. Select the COM port and baud rate. (Note: Baud rate is 115, 200 for USB cable) Then click CONNECT. Keep crossflight still and wait. Now connected. Move the crossflight and we can see it connects well. For more details of crossflight flight controller: https://www.radiolink.com/crossflight Purchase link of crossflight flight controller: https://www.radiolink.com/crossflight... You can send emails to [email protected] if you have any questions when using our products. #rcplane #rcairplane #flightcontroller #radiolink