Harrison M300 lathe - Messing with the lathe bed and its gap.
Perhaps unwisely, I remove the lathe bed from the base. Then I give it a good clean. It won't make the lathe bed any more accurate, but it will allow me to paint it which seemed worth doing whilst I've got everything apart. I'll leave the question of accuracy until the lathe is back together again and I can take some test cuts.
▶︎
Harrison M300 lathe - Apron refurb part 1
▶︎
Harrison M300 lathe - Single point threading part 2: pitch mismatch mystery
▶︎
She Was Trying to Cut It With Scissors and The Grass Was Taller Than My Mowers
▶︎
Harrison M300 lathe - reinstalling the apron
▶︎
This Engine Breaks ALL the Rules
▶︎
I Built Retracting Casters that are Actually GOOD
▶︎
Ich habe 100 Tage ARK Valguero gespielt und das ist passiert...
▶︎
God Says:"I JUST CONFIRMED — ONLY YOU CAN SEE THIS LETTER"/God Message Now/God Message
▶︎
Harrison M300 lathe - trying to turn between centres
▶︎
Harrison M300 lathe - Apron refurb part 3
▶︎
What's NEW at✨SAM'S CLUB✨ + June 2026 INSTANT SAVING!!
▶︎
Whitworths 1862 Slotting Machine
▶︎
After My Wife Passed Away, My Daughter-in-Law Smiled At The Inheritance Meeting!! | Calm Dad Stories
▶︎
Harrison M300 Installation and modifications Part 1 of 2
▶︎
My NEW Harrison M300 Lathe
▶︎
My HAFCO AL320G Lathe Sprung an Oil Leak... Here's What It Took to Fix It
▶︎
This Simple Lathe Tool Changes EVERYTHING…
▶︎
Harrison Lathe - Part 1 - The New Acquisition
▶︎
ASMR Most Brain Melting Triggers Ever 🤤 99.9% of You Will Sleep / 4Hr (No Talking)
▶︎