Ford Fusion Headlight Bulb Socket Connector Change for 2010, 2011, 2012 including Milan, Lincoln MKZ

DIY video on how to change, replace bad socket connector for the H11 low beam (daytime) headlamp light bulb on a Ford Fusion S, SE, SEL for the model years 2010, 2011 and 2012. Also works for Mercury Milan, and Lincoln MKZ. Often times when a light is it, it's the bulb that is too blame. But as these cars age, the plastic bulb socket (connector) begins to disintegrate and fall apart , making a poor intermittent and sometimes no connection. When this happens, your only solution is to replace the old socket with a new socket. It's a tricky job, but possible. Patience is needed. Part: H11 Socket Connector Car shown: 2010 Ford Fusion S Tools Needed: Crimp tool (cheap on Amazon) Crimp connectors (cheap on Amazon) Wire Stripper (with 18 gauge) Wire cutter Electrical tape Needle nose pliers Helpful Tips: Wear long sleeves Ford Fusion Playlist:    • FORD FUSION DIY Handy Val Playlist   Please see my Handy Val channel for my many Ford How-To videos on a number of ranging topics, and don't forget to subscribe as I post new videos regularly. Disclaimer - The content of this video is available for informational and educational purposes only. It is not intended to be a substitute for professional advice. I do my best to provide accurate and complete information, however, I assume no liability for any property or personal damage that may arise from any of the information contained in this video. Due to factors beyond the control of Handy Val, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Handy Val always recommends safe practices.