Самодельные пальцы для экскаватора без токарного станка Замена пальца на гидроцилиндр замена втулок

Making your own pins without turning Homemade pins: Simply buy a rod of the required diameter and simply cut blanks to the required length, which will become the new pins. Minimal machining is required, and the result is fantastic. I used 25mm and 30mm rods, which are called SK rods. The required size is the same. For example, I needed a 25mm pin, so I purchased an SK 25 rod. Your size may be different. At the time of purchase, I paid 4100₽ for two rods. SK 25x1000 rod: 1600₽ SK 30x1200 rod: 2500₽ I think the cost is reasonable, but considering I couldn't find pins of the required sizes, this is a great option. This way, I not only saved money, but most importantly, my time and nerves. I hope this information is useful to everyone. Good luck and all the best.