How I built a Roll Over Jig/Rotisserie for the MK1 Rabbit Project

I needed a roll over jig to get to the underside of the rabbit to clean all the undercoating and get it as neat as possible before going to the sandblaster. After a bit of research and getting a few tools I dove right in. It's not the prettiest but it works well! Purchase List: 1.750 X 1.750 X 0.065 SQUARE 48.00 Inches X2 0.750 X 0.095 ST DOM TUBE 12.00 Inches X1 1.000 X 0.095 ST DOM TUBE 12.00 Inches X1 1.500 X 1.500 X 0.125 ANGLE 43.00 Inches X1 1.500 X 1.500 X 0.125 ANGLE 40.00 Inches X1 1.500 X 1.500 X 0.125 ANGLE 15.00 Inches X10 2.000 X 2.000 X 0.065 SQUARE 54.00 Inches X4 2.000 X 2.000 X 0.065 SQUARE 40.00 Inches X2 Costed me $265 with local pick-up. My Pivot point was 41.5" off the ground. Depending on how long your distance is to the bumper mounts these numbers can fluctuate. But mine was about 12". Check on CAD to be sure I recommend. Follow me and the build: Instagram: @TopSecretR35 /   / topsecretr3.  . Twitter: @TopsecretR35 /   / topsecretr35   Facebook Page: TopSecretR35 Disclaimer: Due to factors beyond the control of TopSecretR35, I cannot guarantee against improper use or unauthorized modifications of this information. TopSecretR35 assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. TopSecretR35 recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of TopSecretR35, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not TopSecretR35.