Calibrating a Haas Probe and Tool Setter on a CHC Controller (Pre NGC)
I purchased a WIPS (Wireless Intuitive Probing System) probe and tool setter from Haas. Because my machine is a 2009 machine, and therefore has the CHC (Classic Haas Controller), there is a lot less information out there about calibrating the probe. Plus, because of the tight installation, they had to angle it at 45 degrees. VQC Instructions: https://www.haascnc.com/service/troub... Tool Probe Mount: https://exactengineeringshop.com/coll...
▶︎
3D EDGE FINDER - calibration and usage
▶︎
Setting up a Wireless Probe and Toolsetter on MASSO
▶︎
Automate Using Your Probe! Make the Most of Your Probe with Macros – Haas Automation Tip of the Day
▶︎
Haas startup, setup, and running a job
▶︎
Setup and Initial Calibration of a Renishaw Tool Setter
▶︎
Replacing Renishaw Probe Stylus, Tool Tuesday Ep.15
▶︎
Manually Setting Up Your G54 X & Y Work Offsets with an Edge Finder
▶︎
Use Vector Probing to Probe a Half Circle - Haas Automation Tip of the Day
▶︎
How to Calibrate HAAS OTS & Spindle Probes
▶︎
Calibration of Renishaw probes on a Haas milling machine part 1 + COMPETITION / Calibration of Re...
▶︎
"3D Printed" Epoxy Injection Mold, Part 1
▶︎
Fanuc Tool Frames
▶︎
Wireless Probing How-To PART 1 - Calibrating the System - Haas Automation, Inc
▶︎
Setting up G54 Work Offsets with the Renishaw Work Probe
▶︎
Converting a Precision Matthews Mill to CNC with MASSO | Part 1
▶︎
Setting up and Programming a 5 axis trunnion
▶︎
CNC Project: FS4MG - Part 2
▶︎
HAAS 3 Probing Systems
▶︎
Hass sl20 lathe setup part 1
▶︎