Rwd Sprint 2 Drift Chassis Layout - Part 2: The full walkthough

Hey guys, I know you have been requesting a full video that goes into detail the entire build of my 2wd Sprint 2 Drift. Its finally here. I know its a long video, and in some parts I tend to ramble on a bit. My thoughts are that if you commit to the changes, it does make the car fun as a 2wd drift car. I really had lots of fun with this chassis, and I hope you will to. Also, you can follow my other builds on my instragram: countdriftula http://www.imgrum.net/user/countdrift... Depending on your chassis layout of where you put your electronics, you may need to get small RC weights to help balance the car. You want to have enough weight on the front, to keep the front tires planted. I just positioned some weights around the front end, I did not use glue or anything to make them stick, as I like to vary the weight distribution with the different body types that I run. Here are some parts that I used: -screws: https://www.amainhobbies.com/jammin-p... -plastic traxxas 2wd bellcrank: http://www.rchobbyexplosion.com/Traxx... -plastic 2wd traxxas caster blocks (I cut the bottoms off, and just used these to attach the bearing carrier/knuckle to the A-Arm) http://www.rcsuperstore.com/Traxxas-3... -traxxas aluminum bellcrank posts: https://www.rcplanet.com/Traxxas_Bell... -traxxas turnbuckles: (I used various sizes, but here is a link to 49mm size, just for reference.) https://www.amazon.com/Traxxas-3643-T...