(Kullanırken Sakın Yapmayın) Philips Espresso Makinesi Letto Go İnceleme #lattego #philips #espresso

The actual use of cleaning products is explained in the other video:    • (3 Aylık Kullanım Sonrası) Philips Espress...   0:43 Inserting the Milk Container 1:00 Correction: There's a different mechanism there; it doesn't actually draw in the milk, it releases steam. As the steam passes through a thin channel, it creates a vacuum effect, drawing the milk in and blending it with the steam. This way, depending on the steam density, hot milk or foam is produced. 2:09 How the device works / Automation 4:24 What happens if the internal mechanism calibration setting is incorrect? 5:59 Opening the machine, accessing the grinding motor, circuits, and pumps. 7:42 What not to do when using ground coffee. 10:10 I gave a little bit of misinformation here. How does the machine know if it's ground coffee for espresso or ground coffee for the filter paper? :) I was actually going to say it could be due to choosing regular or Americano coffee. If it fills too slowly, some pores may be clogged. Running the 5-minute brewing unit cleanse in the cleaning mode will most likely solve that problem. Please don't rush to set up the machine without consulting the instructions like I did :) Most things are actually explained on the instructions when you examine them carefully. Other important notes: • Don't add ground coffee while there's a noise coming from inside the machine. As I showed in the video, the coffee will disperse into the coffee bed, not into it. Otherwise, don't add ground coffee until it's ready. • With ground coffee, there's no "fill it to the top, then pour coffee after coffee." It's a one-time pour. So, with the exception of a few scoops, each coffee you pour will fill the coffee bed, as I showed, and then fill it up to the top of the discharge opening. Then, when the mechanism is activated, the first filled section will slide to be pressed. Any excess ground coffee remaining on top will disperse back into the machine. (It can be cleaned.) • Ground coffee you accidentally filled this way may have stuck to the channel due to the steam and not falling down. However, when viewed from above, the channel may appear full. In this case, you can push it with the back of a long measuring spoon. However, make sure the machine is in the ready position. • Coffee grounds fall into the discharge area on the bottom layer. If you see coffee grounds in other areas, such as further back, where wastewater is collected, or if you see coffee grounds in the interior of the machine, you're doing something wrong. • I forgot to show the inside of the machine again at the end of the video. If you don't make the mistakes I mentioned, there's no dirt inside; it's clean. However, over time, it can splash around as the internal mechanism works. You can clean these with a damp cloth. I wanted to explain the problems I encountered. I discussed how the device works and the potential user errors. We bought the device for use in our dental clinic. It works well. We also liked the coffee temperature. If you're ever in Gaziantep, we'll be waiting for you :)