90 Degree Pendant Bar with Swirls - Cheryl St. Pierre of Majestic Wire Artworks

Supply list below: Coming soon are my Channel Memberships. I have a video on it in the comment section of the channel. This is a great way of helping sustain my channel, as well making my channel more interactive. I will be eventually shutting down my Patreon channel. This will have everything all in one place. Please check it out.    • Membership Level Introduction   Should be live in a few days Supply list: Note: all wire I have used was dead soft raw copper. . 6.5 inch(16.25 cm ) Piece of 16 gauge (1.29mm) wire (easiest to work with dead soft) 2 x 15 inch (37.5 cm) Pieces of 20 gauge (0.81mm) dead soft wire bend in the centre Then measure 3 inches (7.5cm) from the loop to trim. Note: I have given the links for my pliers as I have had so many requests for the pliers I use. I am not stating that you must use the same pliers that I am. Chain Nose Pliers - https://www.beebeecraft.com/p-pandaha... Round nose pliers - https://www.beebeecraft.com/p-benecre... Flush cutter/snips - https://www.beebeecraft.com/p-nbeads-... ruler anvil or hammering surface Hammer to make desired hammered affect. I used a ball peen hammer. Thank you Beebeecraft https://www.beebeecraft.com/ for these magnificent pliers Oh and remember to use CHERYL2020 to get a $5 off coupon when making an order of $40 USD.. Shipping is free on orders over $25Supply List