Flywoo Explorer LR 4 Goku F745 Nano stack replacement/installation

It's not until you record yourself speaking that you realize how many times you sniff, smack your lips, or clear your throat. Please forgive all of that! Hope you get something out of this tutorial/vlog. I had a good time working on this project - editing this video was a pain though! Here in this vlog I've captured the process of replacing the flight controller and ESC stack in my Flywoo Explorer. My previous stack I accidentally shorted and blew out the battery monitoring circuit. It really is a pain to fly long range without battery stats, so I bought a new stack from Flywoo and went through the process of swapping it out - resoldering all the motors, RX, VTX, etc. (These aren't affiliate links, I'm too lazy for that. But maybe someday I will do that. Don't hate me for it!) .: Drone Gear :. Flywoo Explorer LR 4 v2 https://tinyurl.com/2p89rcdv Goku F745 Nano stack w/ BS35A (35 amp) ESC https://tinyurl.com/2p89rcdv MIP Hex Driver Set https://a.co/d/hFpN7uZ .: Soldering Gear :. Tin Lead Rosin Core Solder Wire (0.8mm 100g) https://a.co/d/3PTefJC (Same stuff recommended by Mr Steele) Hakko soldering station (I use a much older Hakko but the quality is still there) https://a.co/d/dkBmHMK 00:00:00 Introduction 00:01:50 Unboxing 00:05:30 Teardown 00:30:50 ESC Install 00:40:45 FC Prep 00:49:26 BT Module 00:53:42 Buzzer 00:55:38 GPS 00:57:28 Caddx Wiring 01:01:03 FC Install 01:04:06 Caddx Install 01:08:27 RX Install 01:10:11 Screw down 01:18:50 Redoing Capacitor 01:21:15 Tighten everything 01:24:14 Caddx Antenna 01:28:26 Buzzer Install 01:31:02 BLHeli 01:33:47 BetaFlight 01:47:12 Hover Test 01:47:47 Final Betaflight Tweak