How to build a REAMP box and WHY you need one

What is a reamp box, why would you use one and how to build it for about 20$. Schematics: https://ibb.co/BPwvDnS Parts list: Box: Hammond 1550A or any metal box bigger than 89x35x30mm https://si.farnell.com/hammond/1550a/... XLR Connector: Neutrik NC3FAV1 (any XLR connector will work) https://si.farnell.com/neutrik/nc3fav... Jack Connector: Any two contact mono jack in plastic housing (like Neutrik NMJ4HF-S) https://si.farnell.com/neutrik/nmj4hf... Transformer: VTX-101-1604 (or any 600:600ohm line level audio transformer) https://si.farnell.com/vigortronix/vt... Resistor: 10kOhm (250mW power rating is enough) https://si.farnell.com/multicomp/mcf-... Potentiometer: 100kOhm Logarithmic https://si.farnell.com/tt-electronics... Switch: SPST or SPDT toggle switch https://si.farnell.com/multicomp/1ms1... Knob: 6mm round shaft knob (any 6mm knob will work - it's best to keep the diameter at 16mm or less) https://www.tube-town.net/ttstore/cla... You can find these components on other sites as well, often cheaper. ----------------------------------------------------------------------------------------------------------- Software for frequency and distortion analysis: RoomEQWizard: https://www.roomeqwizard.com/ ----------------------------------------------------------------------------------------------------------- Facebook:   / lifeharmonic   Instagram:   / lifeharmonic