▼ Ortur Laser Master 2 review | The difference with it's smaller brother

BUY THE LASER HERE: http://gbe.st/302B2ZW (Affiliate link) In this video we take a look at the Ortur Laser Master 2 engraver, the big brother of the Ortur Master, which I watched earlier, see these links: https://3d-printcreator.com/ortur-las... WATCH NEXT: Make an Air Assist Unit for your diode Laser Engraver    • ▼ Best Ortur Master (II) Air Assist Unit |...   The Ortur Master 2 is therefore the big brother, with a worktop measuring 40 by 45 centimeters. The tested machine has a laser of 4.5 Watt actual output, but is called the 15 Watt version on the website. This is because the power of diode lasers is always stated in the power consumption of the whole device, and not in the actual power that the laser uses for engraving or cutting. In this review I also use the lightburn software. This is not the free software that you get with the laser, but if you want to see that software you can watch one of my earlier videos about the Ortur Master lasers, which use exactly the same software. I use the much more professional lightburn software here, because it allows much more, but this software is not free. You can find more info about lightburn on this website: https://lightburnsoftware.com/ In short, the Master 2 is exactly the same as the normal Ortur Master I discussed earlier, only in a larger frame. However, this larger frame makes a lot of difference, because the protruding arm of the small Master can hang at an angle, which means that the distance between the laser and the object can vary during engraving. This is impossible with the Master 2, which gives it a much more consistent result. If you are interested in the Ortur Master 2, keep an eye on my channel because there will be many more videos about this laser machine. By the way, the normal (smaller) Ortur Master laser is still available, and will for some people still be the better choice because it's smaller. It can be found here: https://www.gearbest.com/laser-engrav...