Condenser Fan Motor Possible Bearing Replacement

https://amzn.to/2Qr2BBI 1/4HP Motor 1075 RPM (Ball Bearings) https://amzn.to/2QqluEP 1/3HP Motor 1075 RPM (Ball Bearings) Both Motors Shafts can be cut to fit and both are reversible 48 or 48Y It's a good idea to replace the capacitor when replacing the motor. If the shaft rotates to the left, your motor is counterclockwise shaft end, or CCWSE. To determine lead end perspective, hold your motor up and point the shaft away from you. If the shaft rotates to the right, your motor is clockwise lead end, or CWLE. I was not able to find a replacement sleeve or bushing for this motor. I would have liked to switch out to ball bearings but the motor end bells were tapered, so a ball bearing would not fit. The best solution is to buy a replacement motor with ball bearings. Help support Doublewide6 Repairs LLC by sponsoring his Patreon account   / doublewide6   Doublewide6 Repairs LLC has a Master’s Degree in industrial technology with a specialization in Manufacturing, due to factors beyond the control of Doublewide6 Repairs LLC and anyone featured in his videos, I cannot guarantee against improper use or unauthorized modifications of this information. Doublewide6 Repairs LLC assumes no liability for property damage or injury incurred as a result of any of the information contained in this video or any of Doublewide6’ Repairs LLC's videos. Use this information at your own risk. Doublewide6 Repairs LLC recommends safe practices when working on equipment, power tools, chemicals, electronics, electrical systems, vehicles, and or with tools seen or implied in this video. Due to factors beyond the control of Doublewide6 Repairs LLC, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Doublewide6 Repairs LLC.