Changer et Régler un câble d'embrayage sur une voiture Tuto : Peugeot 205 et autres véhicules

Click to find the pieces at our partner Ch’ti Comptoir! Cable reference: https://lehangardunord.com/215059 Mechanical Basic Kit: https://amzn.to/2Ihy7Ug Brake Cleaner Kit: https://amzn.to/3gdMR3c WD 40 Super Penetrating Oil: https://amzn.to/30ty8KX Paper: https://amzn.to/3fVX7wb Soap: https://amzn.to/2ybB4Ro Protective Glove: https://amzn.to/3arBkfM OUR WEBSITE: https://lehangardunord.com/ Tutorial: https://lehangardunord.com/peugeot/pe... Run the new cable through the front bulkhead. On this vehicle, the inlet is located under the master cylinder. Remove the adjusting screw bolts. Then remove the cup and the plastic strap from the cable. Place the cable in its housing. Next, clip the plastic strap onto the bevel gear. Run the cable through the center of the bevel gear and tighten the adjusting nuts to hold it in place after installing the metal cup. In our case, the cable broke. Since the bevel gear link is held when the cable is taut, it must have fallen onto the road. You can remake one using a grinder. Cut a screw to the correct dimensions and then round off the ends so that it is smooth and rounded. You can then separate the fork from the bevel gear and install your link. This will allow you to operate the fork and therefore the clutch release bearing. On the passenger compartment side, retrieve the bracket and secure it to the pedal using the metal fluxer. Next, install the return spring. Once the spring is correctly positioned, secure the pedal with the screw. Then tighten it with a ratchet and wrench. Then, it's necessary to properly adjust the clutch pedal travel. The travel length is 140mm or 135mm for this vehicle. Add video... Tighten the nut by 13mm, increasing it until you achieve the desired travel. Lock the locknut with a 10mm wrench. Note that manually adjustable cables like this require regular inspection and adjustment. You can test the pedal travel. Reinstall the air flow sensor and the hoses to which it is connected. Then connect the connectors. Install the battery and connect it, starting with the positive terminal. Next, check the coolant level, avoiding spilling any on the exhaust manifold. Attach the air intake. You can start the vehicle and test the gears. The assembly is complete.