OS FS 70. Surpass Part 2/3 Assembly
This engine is still new and I decided therefore not to disturb the valves but then before assembly decided to remove them to clean the valve stems. Before disassembly, the engine was not turning and therefore I just assumed the valves will still seal properly because the engine looked like it doesn't have a lot of run time. There was no visible damage to the valves and I didn't touch the seats. After assembly, they sealed and worked perfectly. I replaced all the O rings and made a new intake manifold gasket. Now for the test run.
▶︎
OS FS 70. Surpass. Part 3/3 Test Runs
▶︎
The Science Behind Million Mile Engines!
▶︎
Мотор від дрона
▶︎
OS FS 70. Surpass. Part 1/3. Disassembly
▶︎
OS 120 FS. Assembly. Part 2/3
▶︎
ASP 52 Second Run A Smokin’ Engine!
▶︎
OS FS-120 Surpass A Look Inside Part 1
▶︎
OS Engines Four Stroke Camshaft Timing
▶︎
The Rise and Fall of Briggs & Stratton, the Engine That Powered Every American Backyard
▶︎
OS Max Engines .46 AXII test run
▶︎
OS 70 Surpass 4 tempos - tirando do coma + Teste
▶︎
O.S. .30 4-stroke set-up and first engine run
▶︎
OS FS 61 break to fix
▶︎
The Dark Story Behind the Napier Deltic: The Bizarre Triangle Engine Powering Rails and Warships UK
▶︎
OS 120 FS. Disassembly. Part 1/3
▶︎
OS FS 70 Surpass Disassembly for Bearing Replacement
▶︎
FLAIR MAGNATILLA - OS FS 70 SURPASS II DISPLAY - 202
▶︎
OS FS 70 Surpass A Cutomer Rebuild Part 1
▶︎
OS FS 26 - Four Stroke Glow Engine Camshaft Timing - Get it right first Time!
▶︎