Making An Indexing Plate For A Victoria (aka Elliott) Dividing Head.
Milling 60 notches in the face of a direct indexing plate for a dividing head. The cutting is being done on a horizontal mill using a profile cutter ground up in a previous video. The notches will have a flat bottom and 30° included angle.
▶︎
Machining a GIANT Radius on a Manual Lathe… What Could Go Wrong?
▶︎
Leitz Optical Dividing Head Teardown P1
▶︎
Making Indexing Plates TIPS #623 DIVIDING HEAD METHOD tubalcain
▶︎
Unimat SL/DB Dividing Head Dooooz and DON'TS
▶︎
Using index plates on a dividing head or rotary table
▶︎
Elliott - Victoria Dividing Head Restoration
▶︎
SHOP TIPS #191 Introduction to the Dividing Head pt 2 mrpete222
▶︎
Making a Milling Slide.
▶︎
MACHINING A 21 TOOTH SPLINED SHAFT . SHOP MADE TOOLING IN USE !
▶︎
Milling Machine Alignment: Tramming the HEad and Vise to Square and Parallel
▶︎
How We Thread 30ft Drill Rods (Wild Megabore Setup!)
▶︎
Machining Dividing Head Index Plates
▶︎
HS366 Making a toolpost grinder - Part 2
▶︎
Spin Indexer Build - Part 1
▶︎
SHOP TIPS #190 Introduction to the Dividing Head pt 1 tubalcain
▶︎
How to Use a Dividing Head
▶︎
New-to-me Mill - Schaublin 13
▶︎
Making a Modified 50:1 Gingery Dividing Head Part 23, the Sector Arms
▶︎
Is This The Dividing Plate Used to Construct The Antikythera Mechanism? - Experimental Archaeology
▶︎