Crap To Cream, setting the ignition timing on my MGB with a supercharger fitted, fixing the issues.
Hi there, if you have seen my other video regarding the set up of the engine with the supercharger, I had suspected issues with the Weber set-up and as highlighted by comments timing could also be an issue. So today I was setting up the timing, additionally the new jets arrived for the Weber 45DCOE so they have been fitted, idle screws also adjusted. With everything set I was going to go out after I had installed my new wheels, found a bulge in one of the tyre side walls, need two new tyres, not available till Monday due to being an unusual size. #mg #mgb #supercharger #issues #setup #timing #weber #45DCOE

▶︎
Supercharging an MGB.....I can't tune it, what am I doing wrong??

▶︎
Ignition timing a whole lot of magic

▶︎
INTRODUCTION TO THE MGB IGNITION SYSTEM | CLASSICMGB

▶︎
MGB Cam Timing Tips: Get the Most from Your MGB Engine

▶︎
1968 MGC Distributor Install, Set Static Timing

▶︎
Supercharging an MGB..... but it doesn't go to plan!!!

▶︎
MGB Electronic Ignition

▶︎
MGB Engine Motor Compression Test Step by Step Guide

▶︎
Fitting AccuSpark Electronic Ignition to MGB

▶︎
1968 MGC Marking Crank Pulley for Engine Timing

▶︎
How Heavy Duty Truck Piston Is Made From Scrap

▶︎
MGB Tuneup Part 2: Break Out the Dwell Meter and Timing Light

▶︎
Crap to Cream, prepping my supercharged MGB for the dyno and continuing the 18V engine rebuild.

▶︎
How To Set Ignition Timing On Your Classic Car

▶︎
MGB Distributor and Spindle installation

▶︎
Electronic Ignition trouble - MGB

▶︎
Making an MGB GT Run Right Again | Timing, Valves & Carb Tuning

▶︎
The Dark Story Behind the Napier Deltic: The Bizarre Triangle Engine Powering Rails and Warships UK

▶︎
Adjusting Valve Lash on 1977 MGB 1800 - Rule of 9

▶︎
