DETAILED! DIY Oversized Tufted King Bed | How to Build a King Bed for $500 | Purp by the Curl

📍ALL MATERIALS/TOOLS USED ARE LISTED IN THE BEGINNING OF THE VIDEO📍 ****Oversize King Bed Dimensions*** Tufted Headboard: 100" extra wide x 79" tall. ---(I adjusted by an inch to fit through my door) Bed Frame: top and side of all 3 rails Side rails 82” long x 12" deep x 12” tall. Footboard: 100” x 16" deep x 12” tall. King size mattress, 76" wide x 80" long. ****MATERIALS*** I used 2inch Plywood for all of the below! Get your board cut at Home Depot or Lowes Items Measurements Quantity Head Board Plywood 100 W x 79 Tall 1 ---Note: My headboard was cut into two pieces in order to equal the above (96W x 31L & 96W x48L). To make the frame 100W, I added small pieces (31L x4W & 48L x4W). I also adjusted the height so it fit my door frame. --only use this if your board is not already 100inch Side Rails Top 82in L x 12in W 6 Side Rails Ends 12 W x 12 W 4 Foot bench Top 100 in L x 16 W 1 Foot Bench sides 100 in L x 12 W 2 ------Fill in the footboard area the same as the headboard; using 1 of each 4W x 16L ; 16W x 12L & 12W x 4L ------only use this if your board is not already 100inch Foot Board Ends 12x12 2 I purchased my materials from Home Depot, Walmart, JoAnns & Lowes --I used between 10-15 yards of fabric ****TIPS**** Purchase fabric using coupons if you're going to a store like JoAnns --this is where I got my fabric from Use Upholstery Fabric for the BEST outcome. Other fabric will work but it may tear Use a work bench if you have it available Use a nail gun for the frame instead of screws if available Drape fabric & leave enough to cover the sides before cutting ****TUFTING PATTERN*** --Headboard 10 x10 from edge --10in in between Footboard Top & Front Start at 4inches from each edge (4 inches from top, side & bottom) on all corners of the bench --then make 8in marks going across horizontally the space between the top & bottom marks is 13in so the middle button should fall at 6.5in Side Rails Start at 2inches from each edge (4 inches from top, side & bottom) on all corners of the bench --then make 8in marks going across 📍This is explained in detail in the video📍